ATV CLASSES $10 entry Fee per Class. 100% Pay Back.

1. STOCK 335cc & UNDER 900 LBS 2X4
2. STOCK 336cc to 425cc 1100 LBS 4X4
3. STOCK 426cc to 601cc 1300 LBS 4X4
4. STOCK 601cc and Up 1300 LBS 4X4
5. UNLIMITED 460cc & Under 1250lbs
6. UNLIMITED 461cc & Up 1500 LBS

A STOCK ATV is considered to have:
• Stock tire height and width.
• 1” variance on stock tire width
• No cut or shaped tires
• No wheel spacers
• No engine carburetor, exhaust ( etc) modifications
• Stock air box (replacement filter allowed)
• No weights within the interior of the four tires
• Maximum hitch height of 14”.
• ATV must have stock appearance
• Rear suspension travel not to be limited

An UNLIMITED ATV can have but is not limited to:
• Oversized/ undersized tires
• Engine Modifications
• Weight Boxes/Bars but not to exceed 24” from front of ATV tires
• Maximum total width of 60” and length of 70”
• Maximum hitch height of 14”.
• NO DEALERS OR DEALER OWNED MACHINES WILL BE ALLOWED IN THE STOCK CLASSES.
• PROOF OF OWNERSHIP MAY BE REQUIRED.

GENERAL RULES
• Driver must stay seated at all times
• Driver must wear helmet
• No sharing of weights with drivers in your class
• No more than 2 machines per driver per class
• No more than 1 run per machine per class
• Minimum of 6 machines to have a class
• No compressed gases
• No one under 18 will be allowed to operate in the unlimited class
• Official's discrimination will be used on stock classes
• No alcohol or drug consumption by drivers on pit crew before or during the events
• All machines must weigh out after their pull and weigh at or under their limit. NO VARIANCE
• All machines must have operating brakes
• If your machine breaks during your pull, you may fix it and move to the last position
• All machines will be inspected in line up
• Machines must have ATV chassis and engine
• Walking speed only. This is for everyone's safety.
• Anyone operating in the unlimited class must wear long pants.
• Hitches will be measured in a designated area with driver and weight on machine.
• BALL may not extend past rear tires or ahead of rear axle. Must have a 1-7/8” ball.
• NON-COMPLIANCE WITH ANY OF THESE RULES WILL RESULT IN DRIVER AND/OR MACHINE DISQUALIFICATION.
• ALL OFFICIAL'S RULINGS ARE FINAL. ANYONE CREATING PROBLEMS WILL BE DISQUALIFIED!!!